Car Battery Installation Near Me

Have you been searching, “car battery installation near me?” In this guide, we’ll review how to install a car battery. Of course, you can always have your vehicle’s battery replaced at our San Diego service center. On average, the car battery replacement cost can range from $75 to $200. Here at the Kearny Mesa Kia service center, we carry an impressive selection of Kia batteries that are manufactured specifically for your new Kia model. Learn more about car replacement batteries, as well as how often to replace a car battery, here at Kearny Mesa Kia near El Cajon.

When to Replace Your Car Battery

If you’re seeking out a car battery installation near La Mesa, you may have already experienced some warning signs that indicate your battery needs replacing:

• Slow cranking or sluggish start
• Low fluid levels in the battery
• Fluid leaking from the battery
• A swelling or bloated battery case
• The “Check Battery” light comes on

How to Install a Car Battery

To change your vehicle’s battery at home in Chula Vista, you’ll need a wrench, battery cleaning solution, the new battery, wire brush, pliers, and anti-corrosion spray. You’ll also want to be sure to wear thick rubber gloves to protect your hands from battery acid or other harsh substances.Then, follow these steps:

1. Turn the engine off and apply the parking brake. 
2. Open the hood and locate the battery. 
3. Loosen the nut connecting the negative, black cable from the battery with a wrench. 
4. Pull the cable off once the nut is loose. Move the nut back and forth or use an anti-seize agent to release it.
5. Using the above steps, remove the positive, red cable from its terminal. 
6. Loosen and remove the clamps that hold the battery.
7. Lift the battery out. 
8. Use anti-corrosion spray to remove corrosion from the battery tray and clamps. You can also use a baking soda and water solution.
9. Take the wire brush and clean off the cable connectors.
10. Place the new battery in and tighten the hold-down clamps.
11. Spray the anti-corrosion solution on the positive (+) and negative (-) terminals of the new battery to prevent corrosion.
12. Attach the red (positive) battery cable first and the black (negative) cable next. 
13. Check the connections and the battery to make sure it’s secure.
14. Start the car to test the battery.

Gain More Automotive Knowledge from the Service Experts at Kearny Mesa Kia

If you’re looking for car battery installation near me, you can leave it to the professionals at the Kearny Mesa Kia service center. Schedule an appointment to save time when running errands in San Diego. Whether you need to know how to jumpstart a car or find a new vehicle, Kearny Mesa Kia has you covered.